CITY OF LOS ANGELES
CALIFORNIA
ERIC GARCETTI
MAYOR
BOARD OF
BUILDING AND SAFETY
COMMISSIONERS
____
HELENA JUBANY
PRESIDENT
VAN AMBATIELOS
VICE-PRESIDENT
E. FELICIA BRANNON
VICTOR H. CUEVAS
SEPAND SAMZADEH
____
DEPARTMENT OF
BUILDING AND SAFETY
201 NORTH FIGUEROA STREET
LOS ANGELES, CA 90012
____
RAYMOND S. CHAN, C.E., S.E.
SUPERINTENDENT OF BUILDING
INTERIM GENERAL MANAGER
LADBS G-5 (Rev.6/08) AN EQUAL EMPLOYMENT OPPORTUNITY - AFFIRMATIVE ACTION EMPLOYER
RESEARCH REPORT NO.: 930483
Approval Date: August 9, 2014
Approval Expires: August 9, 2015
Aerionics Inc.
3601 N. St. Paul Ave.
Sioux Falls, SD 57104
Attn: Jeffrey Christiansen
GENERAL APPROVAL - Carbon Monoxide Detection System - Manufactured by Macurco / Aerionics
Inc. - Controller Model “DVP-120" - Rated 120VAC, 60HZ, 1.0 Amp and Carbon Monoxide (CO) Sensor
Model “CM-6" - Rated 24VAC, 60HZ, 5VA.
DETAILS
This approval is for fire, shock, and electrical hazards only and does not address those aspects of detection
of gases the device is designed or calibrated to detect.
CONDITIONS OF APPROVAL
The installation and use of the carbon monoxide detection system is approved when the following
provisions are met:
1. The Controller Model DVP-120 - shall be plainly and permanently marked in letter heights not
smaller than 1/8 inch on a contrasting background where readily visible with the following:
A. Manufacturer's name, (Macurco / Aerionics Inc.)
B. Model designation, (DVP-120 )
C. Serial Number,
D. Electrical rating, in Volts, Amperes and Frequency, (120VAC, 1.0Amp, 60HZ)
E. “NOT SUITABLE FOR HAZARDOUS LOCATIONS”,
H. “For Carbon Monoxide Detection Only.”,
I. “For use with Macurco / Aerionics, Inc., CM-6 Carbon Monoxide Sensor ONLY”,
J. “For Indoor / Dry Installations ONLY.”,
K. “The installation of this CO detection system shall be based on the conditions of approval
listed in Research Report number 930483. Not valid if RR is not current. For a copy of the
RR visit www.LADBS.org or call 323-224-2168.”
Comments to this Manuals